syncing your pedals is about to get a whole lot easier! The Quartz is an advanced controller that can sync both your Midi and Non-Midi pedals to a specific BPM. Not only that, but it allows you to control basically any other parameter, if the other device allows it! It is designed to fit in to you setup the way that you need it to. Whether you’re the organised type and have each song planned out in advance with presets, or you like to wing it, tap in each tempo, and send custom Midi data when you tap your foot. Or a combination of the two.

The Quartz Timer V2 allows you to control your pedalboard the way that YOU want

Selah Effects

Demo by  Michael Petrowich

Official Product Video

Review by The Gear Page

Review by VGuitar Forum

Product Page

Manual

Quartz Timer v2

Stop tap dancing

Controlling your pedals is about to get a whole lot easier!
Packed in this small footprint is a controller that can be completely customised to your liking and will let you control your entire pedal board from the one place. Not only can you control your devices via Midi, but also via the 4 TRS Jacks (most commonly used as tap tempo outputs).

Whether your pedal accepts a Normally Open tap signal, Normally Closed tap signal, TRS tap configuration, MIDI Clock, or needs a custom Midi Message sent every quarter note, the Quartz can sync them to a specified BPM.

It is also a powerful Midi Controller, sending Program Changes, Control Changes, or any other MIDI message you’d like. Not only can it generate these signals, but can it receive MIDI Clock and other Midi Messages, at the same time passing any other incoming messages through. This enables it to fit in with your favourite MIDI Controller. Each preset can send up to 11 custom midi messages, so you aren't stuck with pre-defined MIDI functions set by the manufacturer.

Review by guitar pedal X

Demo by  UnitedJose

Demo by The Sound Parcel

Review by The Sound Parcel

Review by rjm Music Tech

Quartz Timer v3

Built on the original tone of the V2, the V3 now has midi capabilities, a 3 band EQ, and an additional clipping option. The clipping options are TS, Plexi and the new Germanium clipping. The germanium clipping uses NOS Russian made diodes similar to those found in a popular horsey pedal. It’s not a Klone, just a different flavour. Like the V2 there is still plenty of headroom. The gain knob blends the overdrive into the clean signal, so when the gain is set to zero the pedal acts as a clean boost that doesn't colour your tone. This combined with the new active 3 band EQ gives you much more flexibility in dialling in your sound.

Demo by shnobel

Review by Stompbox Steal

Review by Z-Talk

Scarlett Love v3

A smooth higher gain overdrive.

Our first model, a smooth higher gain overdrive that we released a limited swirl painted run of 15. These sold out really quickly and created a tonne of hype! Since then we have have been working on a generic model to cater for everyone but keep the original tone.

Each Feather Drive has a three way clipping switch that utilises various clipping options. For its standard configuration it comes with TS, Plexi and diode lift options.

Review by Pedal of the Day

Feather Drive

Syncing your pedals is about to get a whole lot easier!
Whether your pedal accepts a Normally Open tap
signal, Normally Closed tap signal, or MIDI Clock, the
Quartz Timer can sync them to a specified BPM. It can
also act as a MIDI controller by sending program
changes. Not only can it generate these signals, but it
can receive MIDI Clock and MIDI Program Changes,
enabling it to fit right in with your favourite MIDI
Controller

Demo by Highfrequency7

Review by reddit /guitarpedals

Quartz Timer

Quartz Timer by Selah Effects