Flat Light is a flanger unlike any other. Taking inspiration from the sounds within flanging, three modes add pitch shifting, additional flanger lines, or echoes to the foundational flanger.

Old Blood Noise Endeavors

Product Page

Review by reddit /guitarpedals

Review by musicradar

Review by delicious audio

Official Product Video

Demo by Eric Merrow

Manual

Flat Light

Float is a dual analog filter pedal. It features two independent filters, independently controllable and routable as stereo, parallel mono, or series mono. Digital control opens up tweakable motion from envelopes and LFOs, or stick with a fixed filter and slide the cutoff as if you’ve just added a synth to your pedalboard. It’s the filter tool greater than the sum of its parts.

Review by Guitar.com

Review by Russo Music

Demo by Stephen McLeod

Float

Stereo Routing-, Split- und Zusammenfühurngs-Pedal. Zwei TRS-IN/OUTs, vier TS-IN/OUTs. Passives Pedal, Strom nur für LEDs benötigt. Typische Anwendung ist z. B., wenn aus einem Stereopedal zwei Mono-Ausgänge kommen, das nächste Signal in der Kette aber nur einen Stereo-Eingang hat. Das T- und R-Signal werden dann einfach zu einem TRS zusammengeführt. 

Split | Meld Is a passive, non-summing, non-destructive way to manage parallel dual-mono and stereo signal paths. 

Split | Meld is an audio routing solution. 

Split | Meld consists of 2 pairs of a TRS (or Stereo) Jack & 2 TS Mono jacks.
The TIP & RING of each TRS jack is routed to a corresponding Mono jack.

Use SPLIT | MELD to route your parallel signal path in a myriad of ways—Especially useful with devices that have TRS input & dual-mono output.

Official Website

Review by Guitar World

Review by Gearnews

Demo by Jam in the closet

SPLIT|MELD

Beam Splitter takes one signal and makes three copies of it, each with differing overdrive voices and delay times. It is specifically our way of creating a huge sound out of a regular one. Output can be kept in parallel mono or split individually to three places. While the goal is singular bigness, you can also find strange filters, flangers, lo-fi vibratos, and trailing slap-back echoes using the delay controls and blending everything to taste.

Beam Splitter

Our AB/Y Switcher is a classic for a reason. Use two footswitches to independently connect A or B to Y, or both A and B to Y at the same time. This passive circuitry is commonly used to switch between instruments at the start of a signal chain, or outputs at the end.

OBNE AB/Y Switcher