Luminary octave generator gives you the ability to dial in any combination of four separate octaves, three presets and an epic steel sounds with the modulation control unengaged.

Luminary Quad Octave Generator v2

The [ACS1]™ is an amplifier and speaker cab simulator delivering the sound and feel of world-class amplifiers, complimentary speaker cabinets created by Tone Factor, and controllable room size. With the ACS1, players have expansive options to deliver their tone whether it's on stage, in the studio, or practicing at home. Simple controls, stereo in and out, onboard presets, and MIDI support make the ACS1 an immeasurable tool in a guitarist's arsenal. Players can also load in their own IRs and update firmware.

Review by musicradar

Review by Gearnews

Review by Guitar Chalk

KO ACS1 Amp & Cab Simulator

A tone tweakers delight, the EB-10 works as a preamp, EQ and boost with three available presets to meticulously craft your guitar's sound allowing for studio-grade electric guitar tone in a live setting. Each rotary knob offers up to 12dB of boost OR cut of Low, Mid, and High frequencies, based on where you have the toggle switches set. When the Boost switch is engaged, add a 10dB MOSFET boost for some great extra punch.

Use the EB-10 to compensate when switching between low and high output instruments. Push through the mix during solos, or even use the onboard presets as three different gain stages by using combinations of increasing boosted EQ settings and the Boost switch! With nine different EQ positions on each knob, bring out new tonal characteristics you didn't know your guitar or bass even had. 

The EB-10 offers two operating modes, “Live” and “Preset”. In live mode, the pedal responds to current position of all the knobs and switches. Dial in a specific sound and turn the pedal on and off with the Bypass switch. In preset mode, the pedal offers preset slots to store three unique sounds. When in preset mode, the pedal is locked on and the user can scroll through the presets by clicking the Bypass switch. The pedal will boot up in the last known operating mode and if that is preset mode, it loads preset 1 by default. Enter preset mode by pressing and holding the bypass switch for 3 seconds until you see the preset light P1 turn on. Repeat to exit. You are in live mode when all preset lights are off. Refer to the manual on saving presets.

EB-10 PreAmp / EQ / Boost

Deep Six Compressor V3

Adding another tool to the musical paint pallet, Walrus Audio is creating another way to design your tone with the Canvas Series Passive Re-Amp. The Re-Amp is a studio tool designed to send recorded guitar, drums, or other instrument tracks from your recording session through pedals and effects, or different amp combinations. The Re-Amp makes it’s appearance to facilitate all-new ways to experiment with your songs.

Produkte

Bau dein Board

Community

Featured Artists

Services

Canvas Re-Amp

Media

Reviews

Technische Daten

Weitere Pedals von Walrus Audio

Walrus Audio

Luminary Quad Octave Generator v2

Walrus Audio

KO ACS1 Amp & Cab Simulator

Walrus Audio

EB-10 PreAmp / EQ / Boost

Walrus Audio

Deep Six Compressor V3

Produkte

Bau dein Board

Services

Community