PWT 12 MK 2

PDI03-JB

Standard aktive DI-Box. Kann über 9V Batterie oder 48V Phantomspeisung betrieben werden. Hochohmiger Eingang, größerer Ausgangspegel als eine passive DI-Box. Die aktive Schaltung ermöglicht die hohe Eingangsimpedanz von 1 MOhm und größere Empfindlichkeit des Einganssignals (typische Differenz zwischen Ein- und Ausgang: -4 dB). Die maximale Ausgansspannung beträgt bei Phantomspeisung +10 dBu. Ausgang: trafosymmetrisch. Durch eine spezielle "floating ground"-Schaltung funktioniert der Ground-Lift-Schalter auch bei Phantomspeisung.

Standard active DI box. Can be operated with 9 V batteries or 48 V phantom power. High-impedance input; higher output level than with a passive DI box. Active circuitry allows for high input impedance ( 1 meg. ohm) and higher input sensitivity (typical difference between in and out -4 dB). Maximum output impedance with phantom power operation +10 dB. Output: transformer balanced. The special "floating ground" circuitry enables ground lift even during phantom power operation.

Product Page

Review by Kemper Forum

Review by adam hall BLOG

Manual

Pan 02

With a stable 250 mA on each of the five center negative barrel style outlets the compact Palmer PWT 05 MKII is most suited to virtually any pedalboard size. To deliver clean DC power to your pedals and eliminate ground loops between them and the associated hum the outlets are single isolated.

The PWT 05 MKII is protected against overloading and comes with 25 and 50 cm long connection cables, as well as two Y-cables. The first one, with a black connector, connects two 9 V outputs to increase the current intensity to a massive 500 mA, the other one, with a white connector, connects two 9 V outputs to double the voltage to 18 V. Also included is a 1-into-5 daisy chain that lets you power five pedals from one output if their total current draw does not exceed 250 mA. The rugged enclosure of the Palmer PWT 05 MKII provides mounting and cable relief options while the IEC mains inlet and voltage selector enable worldwide use.

PWT 05 MK2

The Palmer trave is a passive reamping box that requires no external power supply. Inside is a specially developed transformer that converts the balanced line signal into an unbalanced Hi-Z signal with perfectly matched impedance for your guitar amplifier or effect pedal. At the same time, the trave prevents ground loops, which are otherwise almost unavoidable when you combine an audio interface or mixer output with a guitar amp or effects pedal. The input of this reamping box allows you to switch between consumer (-10 dBV) and professional (+4 dBu) levels, and the output level is continuously adjustable, so you can drive your amp or pedals just the way you like it.

Produkte

Bau dein Board

Community

Featured Artists

Services

River trave

Media

Handbücher

Technische Daten

Weitere Pedals von Palmer

Palmer

PWT 12 MK 2

Palmer

PDI03-JB

Palmer

Pan 02

Palmer

PWT 05 MK2

Produkte

Bau dein Board

Services

Community