APW-3 is a Mid-Low range enhenced traditional Inductor-Transistor type Wah pedal. Most of Wah Pedals need the replacement of pot, but APW-3 is applied to MAGNETIC FIELD SENSING SYSTEM, so it is NO POT-NOISE and MAINTENANCE FREE. You can control Tone range of Wah with Range-Knob.

Artec

Product Page

Demo by  Mister SEHAT Himself

Demo by Sony Tambunam

Vintage Wah APW-3

CPB-12 is individual regulated and individual hum filtered 12-channel power supply. It has ten channels of 'max 100mA at 9V' - fixed voltage outputs, and two channels of 9V / 12V selectable with 'max 300mA'. Also it provide 4 bright LEDs for pedal board lighting. This easy- portable unit includes AC adaptor for power supply. AC adaptor included (AC to DC).

Demo by BUZZBEE TV

Review by bonedo

Review by audiofanzine

Review by The Gear PAge

CPB-12 Power Brick

APW-5 is Tone-Range Switch added version of APW-3 MAGNETIC FIELD SENSING SYSTEM appried Wah pedal.
You can control Tone range of Wah with Range-Knob. It is also used for Bass Guitar by Shift-Down of Tone Range using Bass Switch

Demo by  Putu Suratin Suratin Libhi

Demo by Achmad Rochim Tarega Kimoro

APW-5 Dual Mode Power Wah

APW-7 is Whish Control function added version of APW-5 MAGNETIC FIELD SENSING SYSTEM and Tone Range Switch appried Wah pedal.  It makes 'Whistle' sound by adding Resonance using Whish Knob.

Review by Ultimate Guitar

Review by JoTech Guide

Review by Musiker-Board

Demo by zurowetz

Demo by  Jean Choi

APW-7 Dual Mode Whish Wah

SE-DI2 has two individual channels of active direct interface. This pedal can work with 9V battery or 48V phantom power from linked amp or console. Link switch can select individual 2 ch mode or two balanced output link mode. Each channel has gain attenuator switch. Ground LIFT switch can isolate the ground level between amps or console. but phantom power not applied on ground lift mode.

Manual

Official Product Video

SE-DI2 Active DI-box/splitter

SE-DI2 Active DI-box/splitter von Artec